Mother of all RV Internet

We travel in our RV to get away from the city, and enjoy remote places. That said, I have a job, and I need to be in contact in case of emergencies. Having Internet everywhere enables me to travel more than I otherwise could enjoy.

So as much as possible, I want Internet everywhere. I even have a satellite phone onboard. Its not a good solution though. The costs are horrendous and the data rate is something like 59kb. You can send a few messages if you are lucky, or read an email. That’s about it.

So first I tried the weboost experiment, and it didn’t really pan out for me.

It boosted the signal all right, but did not result in a usable increase in data bandwidth. I might never have realized this, but when I tried to measure the performance of various antenna alternatives I discovered none of them seemed to do much for me, unless you count the joy of having more “bars” (while actually still having no signal).

It seems to me that the weBoost works strongest for voice and maybe 3G signals, which end this year anyway. Although there are a lot of claims of increased LTE performance too, I was not able to replicate that. (Its possible that with the large “OTR” antenna mounted high up I might have had somewhat better results.)

I really need to have Internet when I travel, so on to plan “B”.

I started experimenting with “Mimo” antennas, which is simply an external LTE pair of antennas that you connect to a router or a hotspot.

I started with a Verizon 7730 hotspot which I already had, and an LTE antenna by AntennasPlus.

That seems to work a little. I got some dramatic increase in UPLOAD speed in a rural area, which can be useful, because if you can’t send anything you can’t receive either.

Still I wanted more.

I wanted the mother of all RV Internet. Most of the serious technical discussions on the internet center around using a router and an external antenna.

So with a gasp I ordered the Cradlepoint IBR900, a dual sim mobile LTE router which sells for a whopping $850 on Amazon. (Sounds high, but hey, my phone costs that much)

Next I outfitted it with both Verizon “unlimited” and AT&T “unlimited” sims. There are going to be places that only have one or the other.

And finally the MobileMark roof antenna. I opted to get the magnetic version (that goes on a steel disk) as its easier to replace and I want to share the hole I’ll have to drill with a Sirius antenna.

It turns out the roof drilling part was not as scary as it seems. I just cut a little hole in the ceiling with a knife, and started drilling with a 1 1/8″ bit. The reason for the large hole was to shove a 1″PVC pipe down the hole. I started upwards from inside as I wanted that precise but did not care if I was an inch or so off on the roof.

One the leader drill went through, I finished topside. The actual final drilling was a piece of cake:

Here is a completed view of the whole project:

I would like to find some sort of grommet or something for the inside hole, which is drilled in my entertainment center above the TV. You can’t see the hole unless you stick your head in the cabinet and look up. But since its a standard 1″ PVC pipe I should be able to find something to make it look finished:

What I ended up doing was, using a very high quality Bud Industries aluminum powder coated box. I used cable glands by McMaster-Carr.

The router is housed in my entertainment compartment on top of the BluRay. I mounted a little lighted switch and pigtailed it off the 12 volt wiring for the Winegard 2.0 which I have never used and am not very likely to now. The green button switch below quickly tells me the Internet is “on”.

As a side project I mounted a marine Sirius antenna on the box for my Pioneer dash radio I previously installed. Finally I purchased a galvanized 13″ metal disk off ebay.

The box is secured by VHB tape. The disk is secured by nothing – just a bead of Dicor. Folks say that’s all that is needed – we’ll see!

So far I am pleased with the results. Note that a lot of the time, I don’t get much better reception than a top quality phone. That is somewhat expected. I am taking a cross country trip in a month which will allow me to really test it better in poor signal conditions.

So far in a couple of semi-rural areas I got better bandwidth than my phone in areas with crappy signal, as measured by the app.

The cradlepoint router is definitely not for the tech-scared. Its cumbersome to set up, although not a lot worse than older home routers. The dual sim feature will enable me to switch to AT&T if Verizon is a no-go. That takes a LONG time to switch – like several minutes – but is fine for my application.

The small wire bundle in the picture is because I decided not to connect the gps cable since I have no real use for it.

Here are a couple tips I added after having this for a month. First, every time you open the sim tray you risk losing the tiny screws. I would suggest surgical garb and a clean room. If you do loose one, there is a replacement bag of 2 buried in the bottom of the box that you would never find unless you read this article.

Second, I spent 2 days in network hell with mine watching it randomly crash after a while.

Eventually I realized it only happened on AT&T, and a call to tech support got it fixed. Turns out there is a known firmware bug – just turn off carrier aggregation, which is under advanced setting in the modem setup.

Here are all the parts off Amazon:

(Paid Links)

The Cradlepoint I purchased off Amazon. The store is called “Wireless N WiFi” and they provided terrific customer service.

The antenna I purchased from 5GStore: Rooftop RV LTE Antenna

One of the reasons I purchased at 5GStore besides the fantastic customer service is they agreed to have the antenna custom made with shorter 3 foot cables. That eliminated a lot of clutter and there is a slight signal gain in making the leads as short as possible.

The cable glands I used are: McMaster-Carr PG-11 Cable glands They require a PG-11 hole, which is what the greenlee punch above is for. It cut through the aluminum like butter.

I slobbered Dicor over everything and declared victory. Note that I am no genius, and just copy what other folks have done. This project is based on ideas from a bunch of sources on the internet.

In particular I’d like to thank “TurboPilot” on Sprinter-Source, RV with Tito, and Mobile Internet Resource Center for the inspiration of this project.

6 thoughts on “Mother of all RV Internet

  1. I also used a similar approach, purchased the Pepwave MAX BR1 as my mobile router. I used dual SIM’s from AT&T and T-Mobile. I have installed a
    SureCall Fusion2Go RV 4G Cell Phone Signal Booster with an Omni Antenna on a Max-Gain System’s MK6 fiberglass telescoping antenna system. The extendable antenna can be extended up to 30 ft above the RV roof top. You are correct this type of system does a much better job of increasing band width access, if connected to a 4G LTE antenna unit.

    I posted these results on Sprinter Forum ->

  2. Thanks Harry! I probably read your posts before as I think at this point I have read pretty much every story on the Internet involving an RV and a LTE router. 🙂

    Mine is still a work in progress. I need to run a 12 volt wire so I don’t have to plug into the inverter. (Edit: That is done!) Also I may revisit the antenna someday but for now the low profile stealthy one will do. I knew I’m giving up some signal that way.

    Edit: Yep I took a look at your article and I remember seeing that – that is one serious flagpole you have there!

  3. Currently in my RV I use a ZTE Mobley VT6200 with ATT 4G .com with unlimited data for $20 a month. Works well enough for me but I am thinking of hacking the Mobley to plug in 2 antennas, but the 4G antennas are expensive.
    Have you research 5G? Do you think with 5G you will still need external antennas? Have you been reading about SpaceX Starlink? I think Starlink will be the answer as it will cover all of North America. Sterling will require a $200 antenna, but I do not know if it will work while the RV is moving like the Mobley does.
    Just looking for your opinion.

  4. Hi Tom,

    I have a satellite phone (globalstar) but find it semi useless for an RV. It won’t work under any sort of tree at all. Unless Starlink is magically different, I am going to assume that any frequencies from space are going to require the same line of sight.

    Likewise, I don’t expect to see 5G in rv anytime soon. From what I understand its poor at both distance and obstacle penetration, so I would assume that rural areas where I RV won’t see 5G for decades if ever.

    I’m no expert on this stuff though, so take it with a grain of salt. My satellite phone antenna is omnidirectional, but I never got a chance to test while moving as I would have to stand on the roof. 🙂

    1. The star link system will not need line of site to one satellite as one antenna may connect up to 3 or 4 satellite at a time plus I think it also depends on the frequency band it used kind of like GPS.
      I do not know much how 5G works myself.

  5. Tom that sounds good I hope Starlink works out I’d love to give Verizon and AT&T the boot. From what I have heard its a different kind of satellite and maybe the problems that have plagued past systems (high prices, high latency) won’t apply as much. But I guess I’ll believe it when I see it! In the meantime I’m not waiting on them who knows when and if they will have something you can use at a decent price. I expect any Internet system I mount in the RV I’ll be lucky to get a couple years out of before something better comes along…

Leave a Reply to Stephen T Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.